lkakchem.blogg.se

Installation is complete, ready for the iPod to be closed. Use two pads if fitting in to a thick caseback. Install iFlash-Solo in to the iPod, make sure the ribbon is fully home, then lock the black bar down.Īttach Foam Pad(s) on top of the SD connector, overlap on to the SD card – this will secure the SD card from releasing from the iFlash-Solo. Make sure the black bar has been raised on the Zif connector. Insert and lock the SD card in to the iFlash-Solo. iPod is ready to accept the iFlash board. Remove all rubber bumpers and strips from the iPods if any remain after the HDD is removed. Gently lift the black bar to release the ribbon from the HDD. Rest the front and back side by side, be careful to not cause too much stress on the headphone ribbon. I suggest watching some iPod opening videos on the internet.īefore pulling the case apart, release the battery cable – lift the black lock bar -or- gently using even pressure pull up the battery ribbon away from the connector. Using suitable tools, release the holding clips, making your way around the case till it opens.